"Extra Sensor" for all FloodStop Systems (pictured below)
If additional floor coverage is desired for even quicker detection/prevention.

• Additional sensor(s) can be plugged into one another in a daisy-chain order (comes with 1 meter wire)
• Example: Additional Sensor allows one sensor to be placed behind the Washer and the other sensor behind the Dryer
• Example: Additional Sensor allows one sensor to be placed inside the water heater pan and the other sensor outside the pan
• Works with all FloodStop products

"Controller to Valve Extension Wire" for all FloodStop Systems (pictured below)
For ease of locating “Controller” further away from “Valve” when desired.

• Use to mount the Controller more than 2 feet away from the Valve
• Consider purchasing a "controller to valve extension wire" (9 feet long/white)
• Mated connectors on each end to insure custom fit with other connectors
• Thin white extension wire makes connection simple and virtually out of sight
• Works with all FloodStop products

"Transformer Extension Wire" for all FloodStop Systems (pictured below)
For ease of installation if an electrical outlet is not close by.

• Water Heaters for example are not always located near an electrical outlet
• Consider purchasing a "transformer extension wire" (12 feet long/white)
• Transformer Extension Wire plugs into end of the transformer’s wire
• Thin white low-voltage extension wire makes connection simple and virtually out of sight
• Works with all FloodStop products

Extra Sensor (and 1 meter wire):

Controller to Valve Extension Wire:

Transformer Extension Wire: