| FloodStop
for Dishwasher or Toilet
Prevent water damage from failed
Dishwasher or Toilet and Supply Line:
Dishwasher leaks are often small and go unnoticed until significant
damage is finally discovered. Such a leak will continue to collect
under the Dishwasher and then seep between the kitchen flooring
and sub-flooring. The damage often goes undetected until the floor
is visually buckled or warped, at which time the damage and cost
to replace is extensive.
Toilet overflows can be the cause of significant property damage.
The actual overflow event typically takes a couple minutes to begin
and often goes unnoticed long after the occupant as left the bathroom. |
 |
| FloodStop (FS 3/8-C) automatically shuts off the water supply to the Dishwasher or Toilet, whether caused by a small continuous leak, broken component, leaking seal, overflow or a ruptured supply line. Powered by AC Adaptor/Transformer or Batteries. Output contacts available, which allow the Controller to connect with Alarm, Home Automation or Auto-Dialer systems if desired. Easily installed in ten minutes. |
FloodStop (FS 3/8-C) Components:
• Motorized Ball Valve (3/8 inch Compression Fitting)
• Control Unit (with Battery Backup 4 X C Size) • Water/Leak
Sensor (1.25” X 7.5”)
• AC Power Adaptor (or use 4 X C Batteries as Primary Power
Source)
• Output Contact Wires (2) |
.jpg) |
How FloodStop (FS 3/8-C) Works:
• The FloodStop valve is connected to the angle stop and supply
line
• Water/leak sensor is placed at the base of the appliance or
fixture (Dishwasher – Toilet – 3/8” Icemaker –
etc.)
• Valve stays open until water loss is detected
• Water on sensor closes FloodStop valve and sounds alarm
• Valve stays closed until problem is attended to and system
is reset |
 |
Without FloodStop, Flooding Will Continue:
Unexpected appliance failures cause flooding and water damage, which will continue unabated until the problem is discovered and the water supply is manually shut off. |
With Flood Stop, Property Damage is Avoided:
Water loss from unexpected appliance failures and supply line ruptures are detected by FloodStop's water/leak sensor, and the water supply is automatically and immediately shut off. |
|
Product Literature
|